cisco_wlc_code_upgrade_and_bin_pre-download
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| cisco_wlc_code_upgrade_and_bin_pre-download [2024/07/14 21:37] – old revision restored (2024/07/14 15:09) 52.230.152.115 | cisco_wlc_code_upgrade_and_bin_pre-download [2024/07/14 23:57] (current) – old revision restored (2024/07/14 15:09) 52.230.152.95 | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| Scheduled the reboot of the controller and APs\\ | Scheduled the reboot of the controller and APs\\ | ||
| - | **Upload the new controller code base**\\ | + | **Upload the new controller code base\\** |
| transfer download mode tftp\\ | transfer download mode tftp\\ | ||
| transfer download datatype code\\ | transfer download datatype code\\ | ||
| Line 22: | Line 22: | ||
| You can also manually specify which APs your want to pre-download to, if that was a requirement. Once you have confirmed that all APs have been upgraded to the new image, proceed to step 3.\\ | You can also manually specify which APs your want to pre-download to, if that was a requirement. Once you have confirmed that all APs have been upgraded to the new image, proceed to step 3.\\ | ||
| - | **Scheduled the reboot of the controller and APs**\\ | + | **Scheduled the reboot of the controller and APs\\** |
| - | Now that we have upgraded the controller to the new release and pre-downloaded the new AP images, we will need to schedule a reload. This is so that the controller and APs can swap to their new images.\\ | + | Now that we have upgraded the controller to the new release and pre-downloaded the new AP images, we will need to schedule a reload. This is so that the controller and APs can swap to their new images. |
| - | To do this insure that APs primary image is the new code, by executing:\\ | + | To do this insure that APs primary image is the new code, by executing: |
| - | show ap image all\\ | + | show ap image all |
| If you need to swap between primary and backup, execute the following command: | If you need to swap between primary and backup, execute the following command: | ||
| - | config ap image swap all\\ | + | config ap image swap all |
| confirm that the new image is active for Access Points. Now we need to schedule the Controller to reboot at pre-determined time. For the purposes of this post, I have set it to reboot 1 minute 30 seconds from now and swap the default partition to the newer version of code and save the running-configuration before the reload\\ | confirm that the new image is active for Access Points. Now we need to schedule the Controller to reboot at pre-determined time. For the purposes of this post, I have set it to reboot 1 minute 30 seconds from now and swap the default partition to the newer version of code and save the running-configuration before the reload\\ | ||
cisco_wlc_code_upgrade_and_bin_pre-download.txt · Last modified: 2024/07/14 23:57 by 52.230.152.95